360° Rotatable Adhesive Dashboard Phone Holder

Hold your phone or GPS device steady on the dashboard with a holder whose base turns a full 360 degrees and locks in place with one hand. The soft, textured silicone back and the auto-locking design keep the device in position over bumps, sudden movements, hard braking and sharp turns.

Rotating base for the right viewing angle

Because the base turns all the way around, you can set the screen to the angle that suits you. This helps cut down on reflections and keeps your attention on the road.

One-hand fitting

Tilt the phone at 45 degrees to slot it in. Then the holder locks in place in just 0.1 seconds, so you only need one hand.

Strong grip on bumpy roads

The holder is rated at 20KG of suction power and is designed to stay put even on bumpy roads.

The base is fixed with 3M primer rather than suction cups. Extra primer is included in the package. It is not recommended for leather surfaces.

Installation

Double spring clips hold the phone from both sides and lock automatically.

• Clean the installation surface and check that it is flat and at an angle of less than 15 degrees.
• Avoid greasy or uneven surfaces. Repositioning it often may weaken the adhesive.
• Place the phone horizontally.
• Use larger devices such as iPads only while the vehicle is stationary, to prevent falls.

Only fit the holder to a flat dashboard. Its base area is 10 square inches. Keep it away from air vents, where it could damage the vent or affect safety, and away from your line of sight.

Compatibility

The holder works with phones and GPS devices between 6-13mm thick, including the iPhone 16/15/14/13 series, the Samsung Galaxy S and Note series, Garmin and more. It is designed for phones measuring 4-7 inch. Make sure the thickness of your device with its case does not exceed 13mm.

The snap fastener design and silicone protective layer suit many different phone cases.