Gen 3 Standard Flat Mount for Satellite Dish

Starlink Gen 3 Standard Flatmount

Keep your Starlink sturdy and out of sight. This flatmount is the best fit for using Starlink while travelling under typical transport conditions. Its sleek, low profile installs without tools.

Built for durability

This mount is made from injection-molded ASA plastic with UV resistance. It is rated for temperatures from -40°F to 150°F (-40°C to 65°C).

The low, slender design leaves the Starlink dish surface fully exposed, so signal and heat transfer continue without obstruction.

What is included

• Gen 3 Standard Flatmount

The mount is available in black and white. It does not come with attachments, so you choose the attachment method separately to suit your vehicle and use. The options are rubber-coated magnets, VHB metal discs, VHB adhesive landing pads, heavy-duty suction cups and swivel leg mount adapters.

Frequently asked questions

Can I use it while driving at speed or in high wind?

Yes. This mount is engineered and tested for high-wind and rough-condition use. Once it is installed on a clean surface and does not move when you push it firmly, it is ready to drive. If you chose suction cups, check the suction with a quick test before every drive.

How do I attach it to an aluminum roof?

Aluminum is non-ferrous, so attachment depends on how permanent you want the install:

• Permanent: use VHB adhesive landing pads, which bond directly to the aluminum.
• Semi-permanent: pair rubber-coated magnets with VHB metal discs. The disc bonds to the aluminum and the magnet locks onto the disc, giving a strong hold that you can still remove later.
• Fully removable: use heavy-duty suction cups.

How do I attach it to a fiberglass roof?

Fiberglass is also non-ferrous, so the setup is the same as for aluminum:

• Permanent: use VHB adhesive landing pads, which bond directly to the fiberglass.
• Semi-permanent: pair rubber-coated magnets with VHB metal discs. The disc bonds to the fiberglass and the magnet locks onto the disc.
• Fully removable: heavy-duty suction cups also work.

For a curved surface, use swivel leg mount adapters. Each leg moves independently, so the mount can conform to the curve and sit flush without rocking.

Can it be used on a Ford roof?

Most Ford trucks newer than 2016 have an aluminum roof. The attachment options above apply, and the mount will hold when you use one of them.

How strong are the magnets?

Each magnet has 60 lbs of holding force, so all four magnets together hold up to 240 lbs. To remove them, slide them side to side with some force rather than pulling straight up.

Can I take it through an automatic car wash?

This is not recommended. The mount handles weather and road grime, but automatic car washes put extra stress on the dish and attachment points through high-pressure jets and rotating brushes. Remove the dish before you go in, and also remove the mount if you are using a touchless or brush wash. Reinstall both once you are out.

How is the dish released from the mount?

The Gen 3 Standard dish slides into the flatmount via its removable kickstand. To release it, access and press the kickstand tab. If the mount is hard-mounted with through-bolts or VHB landing pads, the tab becomes hard to reach once installed.